Home » Build Home Plans » How To Make A Plant In The Trunking External Lighting

How To Make A Plant In The Trunking External Lighting

Build Home Plans, Home Lighting, Tips and Trick Home Design

How To Make A Plant In The Trunking External Lighting | Lighting system with the external characteristics of the race to illuminate areas such as, terrace or balcony without broaching the wall. This project is to identify the most appropriate point in the electrical system to connect, this is usually where the nearest box to the electrical circuit. Step by step guide will show you how to proceed in the installation also uses images that illustrate the steps of the job.

Work starts from the distribution box and look for interesting holes equidistant from each other, all the way from the raceway, which is used as a guide to go to fix the collar. Practice all the holes and insert plugs therein, wherein the collar and then screwed to lock the wall. Insert the snap lines that go to complete the connection curve. The back of the lamp fastened to the wall and accept the involvement of channels containing a variety of electrical cable. For wall mounting should mark points to proceed to the hole, using if necessary, to the level of alignment.
How To Make A Plant In The Trunking External Lighting How To Make A Plant In The Trunking External Lighting
Before making electrical connections to the existing system, you should make a new start passing the wires in the channel. From the junction box must start two wires to the bulb and five of the switch in the outlet. To connect the cable to a junction box on strippers and a half and twist the wires, put them in a hat that has a clamp that insulation be tightened with a screwdriver. The cable must incorporate them into the terminal phase of the neutral and the house light and block them by tightening the small screws used to fix many.

After all the bear wires with a special tool, begin to connect in the flush box. Now connect the switch: the input terminal on the back is the phase wire from the power cables connected to the lamp. After connection you can pinch the fruit in their seats and close the box by inserting the screw. This type of box to use is external, then the water is isolated. Switches and sockets, each of which is protected by a rubber cover, which allows operation without being picked up.

Related How To Make A Plant In The Trunking External Lighting

Various Tricks In Kitchen

The kitchen becomes a place where we process food. A good kitchen design

How to Structure Electric

How to Structure Electrical Systems at Home  | With this guide we will

Design Open House, Feels

Design Open House, Feels Relieved and Many Air | Couple Asrul St. Basari

How To Read A Scale Drawi

How to Read a scale drawing Design House | Usually the technical picture is